Steel Products Prices North America
Weekly Raw Steel Production Declines
Written by Tim Triplett
September 12, 2017
Domestic raw steel production totaled 1,733,000 net tons in the week ending Sept. 9, an 8.9 percent increase from the same period last year, but a decrease of 0.8 percent from the prior week. The mill capability utilization rate was 74.3 percent, down slightly from 74.9 percent the prior week, but up from 68.0 percent the prior year, reports the American Iron and Steel Institute in Washington.
Adjusted year-to-date production through Sept. 9 was 62,633,000 net tons, up 3.3 percent from the same period last year. This year’s capability utilization rate of 74.6 percent is an improvement on the 72.1 percent in 2016.
Following is production for the Sept. 9 week by district: North East, 206,000 net tons; Great Lakes, 709,000 net tons; Midwest, 159,000 net tons; South, 589,000 net tons; and West, 70,000 net tons, for a total of 1,733,000.
The raw steel production tonnage in this report is estimated. The figures are compiled from weekly production tonnage from 50 percent of the domestic producers combined with monthly production data for the remainder. Therefore, this report should be used primarily to assess production trends. The AISI monthly production report provides a more detailed summary of steel production based on data supplied by companies representing 75 percent of U.S. production capacity.
Mill capability for the third quarter is approximately 30.6 million tons, compared to 30.7 million tons for the same period last year and 30.3 million tons for the second quarter.
Below is a graph showing the history of weekly raw steel production. You will need to view the graph on our website to use its interactive features, you can do so by clicking here. If you need assistance logging into or navigating the website, please contact our office at 800-432-3475 or info@SteelMarketUpdate.com.
Tim Triplett
Read more from Tim TriplettLatest in Steel Products Prices North America
SMU price ranges: Sheet, plate largely unchanged
Sheet prices varied this week. While hot-rolled (HR) coil pricing was largely flat, cold-rolled (CR) coil and tandem product pricing eased slightly reflecting the momentum shift seen last week for HR coil. SMU’s average HR coil price was flat from last week at $835 per short ton (st) – potentially emphasizing the tension between competing […]
Nucor posts $830/ton spot HR price for week of April 8
Nucor said its spot hot-rolled (HR) coil price this week will be $830 per short ton (st).
US HR prices rebound, no longer near parity with imports
US hot-rolled coil and offshore hot band moved further away from parity this week as stateside prices have begun to move higher in response to mill increases.
Galvanized buyers report solid demand, balanced inventories
Galvanized buyers reported solid demand and balanced inventories this week and were anticipating the sheet price increase announced by Cleveland-Cliffs on Wednesday.
HRC vs. CRC price spread jumps in second week of new year
The spread between cold-rolled coil (CRC) and hot-rolled coil (HRC) prices jumped during the week of Jan. 8 as cold rolled tags continued to rise while hot rolled tags held steady.