Steel Mills
MSCI: Carbon Flat Rolled Down to 2.0 Months of Supply
Written by John Packard
September 19, 2017
The Metals Service Center Institute (MSCI) reported carbon flat rolled steel inventories as growing in August compared to the end-of-July 2017 data, but still below August 2016 levels. MSCI data shows the number of months of flat rolled supply at very low levels.
This week, MSCI reported total steel shipments (all products) during August out of U.S. service centers at just under 3.5 million tons. This represents a 2.7 percent improvement over August 2016 shipment levels. The daily shipment rate was 1,200 tons per day higher than what was reported for the month of July.
Both August 2017 and August 2016 had 23 shipping days.
Total steel inventories in August increased above end-of-July levels by 157,300 tons to 7.7 million tons. The number of months of supply on hand at the end of August was calculated by MSCI as 2.2 months. This is down from the 2.5 months of supply reported as of the end of July (non-seasonally adjusted).
Carbon Flat Rolled Months of Supply Down to 2.0 Months
MSCI reported carbon flat rolled shipments during August at 330,800 tons higher than July and approximately 21,000 tons above August 2016 levels. Shipments were 0.90 percent better than a year ago. The daily shipment rate was 900 tons a day better than year-ago levels.
For the year, total carbon flat rolled shipments were 2.4 percent above the first eight months 2016. There has been a steady decline in year-over-year shipment comparisons, which began the year at 9.7 percent above 2016 levels.
Flat rolled inventories rose by approximately 108,000 tons, yet are 5.3 percent below year-ago levels. The number of months of supply dropped on a non-seasonally adjusted basis to 2.0 months.
Carbon plate shipments were reported by MSCI at just below 300,000 tons for the month of August. The daily shipment rate at 13,000 tons per day was the same as the prior month and just 100 tons per day above year-ago levels. For the first eight months 2017, plate shipments were 5.7 percent above year-ago levels.
Inventories of plate stood at 832,900 tons, which is 0.30 percent above year-ago levels. The number of months of supply dropped to 2.8 months on a non-seasonally adjusted basis.
Carbon Pipe and Tube
MSCI reported pipe and tube shipments as 31,000 tons higher than July, but just slightly below 2016 levels. The daily shipping rate was 100 tons per day lower than August 2016 levels.
Inventories remained essentially unchanged and were 9.5 percent lower than 2016 levels. The number of months of supply dropped to 2.3 months on a non-seasonally adjusted rate.
John Packard
Read more from John PackardLatest in Steel Mills
Cliffs moves sheet prices up by $60/st, seeks $900/st HRC
Cleveland-Cliffs aims to increase sheet prices by $60 per short ton (st) and is seeking a new target base for hot-rolled coil (HRC) of $900/st. That's according to a press release circulated on Wednesday morning, March 27.
SSAB could use DOE funding to expand US operations
With the help of a large government grant, SSAB may soon expand its operations in the US – including constructing a fossil-fuel-free green ironmaking facility in Mississippi.
Iron, steel win big in Dept. of Energy’s $6B decarb initiative
The Department of Energy (DOE) announced on Monday six projects that will receive up to $1.5 billion in funding to further decarbonize the iron and steel industry.
Cliffs to use DOE grant to replace Middletown BF with DRI, EMF plant
Cleveland-Cliffs Inc. has plans to replace the blast furnace at its Middletown Works in Ohio with a direct-reduced iron (DRI) plant and two electric melting furnaces (EMFs).
CMC’s Arizona 2 micro-mill shifts focus on West Coast rebar glut
A temporary surplus of rebar on the West Coast is forcing CMC to alter the planned ramp-up of its Arizona 2 micro-mill, the company's leader said on Thursday.