Steel Products Prices North America

SMU Comparison Price Indices: Plate Up While HRC Down
Written by John Packard
February 9, 2014
The various indexes we follow on a regular basis all had prices on benchmark hot rolled moving lower this past week. Platts took the biggest leap moving from $675 to $660 in one week. SMU dropped $5 per ton to $660. Plate prices rose at Platts but dropped with CRU. The result is we are seeing quite a spread between the indexes.
FOB Points for each index:
SMU: Domestic Mill, East of the Rockies.
CRU: Midwest Mill, East of the Rockies.
SteelBenchmarker: Domestic Mill, East of the Mississippi.
SteelOrbis: Midwest Domestic Mill.
Platts: Northern Indiana Domestic Mill.

John Packard
Read more from John PackardLatest in Steel Products Prices North America

SMU Price Ranges: Sheet and plate move ‘soft sideways’ to start August
Sheet and plate prices were either flat or modestly lower this week on softer demand and increasing domestic capacity.

Nucor lowers HRC list price to $890/ton
Nucor’s weekly consumer spot price (CSP) for hot-rolled (HR) coil was adjusted $10 per short ton (st) lower this week after holding steady last week.

CRU: Q3 will be the lowest point in current sheet price cycle
CRU Principal Analyst Shankhadeep Mukherjee expects a restocking cycle for steel sheet products in most parts of the world due to either low inventories or seasonally stronger demand.

CRU: US rebar and wire rod prices rise alongside S232 increase
CRU Senior Steel Analyst Alexandra Anderson discusses current market and pricing dynamics for long steel products in the US.

SMU Price Ranges: Sheet and plate steady ahead of Independence Day
Sheet and plate prices were little changed in the shortened week ahead of Independence Day, according to SMU’s latest check of the market.