Steel Products Prices North America

Weekly Raw Steel Production Dips 2.4 Percent
Written by Tim Triplett
November 28, 2017
U.S. raw steel production for the week ending Nov. 25 totaled 1,703,000 net tons, a 7.0 percent increase from the same period last year, but down 2.4 percent from the prior week. The mill capability utilization rate for the week averaged 73.0 percent, down from 74.9 percent the prior week but up from 67.1 percent the prior year, reports the American Iron and Steel Institute in Washington.
Adjusted year-to-date production through Nov. 25 totaled 81,661,000 net tons, up 4.2 percent from the same period last year. The average mill capability utilization rate for the year to date was 74.5 percent, up from 70.8 percent in 2016.
Following is production by district for the week of Nov. 25: North East: 207,000 net tons; Great Lakes, 616,000 net tons; Midwest, 162,000 net tons; South, 651,000 net tons; and West, 67,000 net tons, for a total of 1,703,000.
The raw steel production tonnage provided in this report is estimated. The figures are compiled from weekly production tonnage from 50 percent of the domestic producers combined with monthly production data for the remainder. Therefore, this report should be used primarily to assess production trends. The AISI monthly production report provides a more detailed summary of steel production based on data supplied by companies representing 75 percent of U.S. production capacity.
Mill capability for fourth-quarter 2017 is approximately 30.6 million tons, compared to 30.7 million tons for the same period last year and 30.6 million tons for third-quarter 2017.
Below is a graph showing the history of weekly raw steel production. You will need to view the graph on our website to use its interactive features, you can do so by clicking here. If you need assistance logging into or navigating the website, please contact our office at 800-432-3475 or info@SteelMarketUpdate.com.

Tim Triplett
Read more from Tim TriplettLatest in Steel Products Prices North America

Domestic plate prices could heat up despite so-so demand, market sources say
Some sources also speculated that plate could see further price increases thanks to modest but steady demand, lower imports, mill maintenance outages, and end markets less immediately affected by tariff-related disruptions.

SMU Price Ranges: HR holds, galv slips amid competing market narratives
SMU’s sheet and plate prices see-sawed this week as hot-rolled (HR) coil prices held their ground while prices for galvanized product slipped.

Nucor carries $875/ton HR list price into week seven
Nucor is keeping hot-rolled (HR) coil prices unchanged again this week, according to its latest consumer spot price (CSP) notice issued on Monday, Oct. 6

SMU Price Ranges: A newsy week sees modest price gains despite a quiet spot market
Market participants predicted that prices should be at or near a bottom. But while most seemed to agree on that point, many also said they saw little upside given a quiet spot market and ongoing concerns about demand.

Nucor increases plate prices by $60/ton
Nucor aims to increase prices for steel plate by $60 per short ton with the opening of its November order book.