Steel Products Prices North America

Mill Capacity Utilization Up to 81.7 Percent
Written by Tim Triplett
November 5, 2019
Raw steel output by U.S. mills increased by nearly a full percentage point in the week ending Nov. 2, the third increase in as many weeks, taking the average mill utilization up to 81.7 percent of capacity. Production totaled 1,888,000 net tons, up 1.2 percent from the previous week and up 0.1 percent compared with the same week last year, reported the American Iron and Steel Institute.
Adjusted year-to-date production through Nov. 2 totaled 81,599,000 net tons for the year at an average mill utilization of 80.3 percent–up 2.5 percent from 2018 when the year-to-date utilization rate was 77.5 percent.
Following is production by district for the Nov. 2 week: North East: 190,000 net tons; Great Lakes, 676,000 net tons; Midwest, 181,000 net tons; South, 767,000 net tons; and West, 74,000 net tons, for a total of 1,888,000 tons. Production for the week increased in the South and Midwest.
The raw steel production tonnage provided in this report is estimated. The figures are compiled from weekly production tonnage from 50 percent of the domestic producers combined with monthly production data for the remainder. Therefore, this report should be used primarily to assess production trends. The AISI monthly production report provides a more detailed summary of steel production based on data supplied by companies representing 75 percent of U.S. production capacity.
Note, capability for fourth-quarter 2019 is approximately 30.4 million tons, compared to 30.8 million tons for the same period last year and 30.6 million tons for third-quarter 2019. Year-to-date totals are adjusted for consistency with monthly data.

Tim Triplett
Read more from Tim TriplettLatest in Steel Products Prices North America

SMU price ranges: Flat-rolled balloon continues to leak
Sheet and plate prices were flat or lower again this week on continued concerns about demand and higher production rates among US mills.

HRC vs. busheling spread narrows in August
The price spread between prime scrap and hot-rolled coil (HRC) narrowed in August, according to SMU’s most recent pricing data.

SMU Price Ranges: Market drifts lower still
All five of SMU's steel sheet and plate price indices declined this week, falling to lows last seen in February.

Discontentment brews in plate market with flat, status-quo pricing
Sources in the carbon and alloy steel plate market said they are less discouraged by market uncertainty resulting from tariffs or foreign relations, but are instead, eager to see disruption to the flat pricing environment.

Nucor lowers HR coil spot price by $15/ton
Nucor has implemented a double-digit price decrease on spot hot-rolled (HR) coil for the second consecutive week.