Steel Products Prices North America

Weekly Mill Capacity Utilization Stays Above 80 Percent
Written by Tim Triplett
November 26, 2019
Raw steel output by U.S. mills dipped again in the week ending Nov. 23, but stayed above the 80 percent mark. Production totaled 1,861,000 net tons at a capability utilization rate of 80.4 percent, down 0.8 percent from the previous week and down 2.2 percent compared with the same week last year, reported the American Iron and Steel Institute.
Adjusted year-to-date production through Nov. 23 totaled 87,198,000 net tons at an average mill utilization of 80.3 percent–up 2.2 percent from 2018 when the year-to-date utilization rate was 78.1 percent.
Following is production by district for the Nov. 23 week: North East: 203,000 net tons; Great Lakes, 673,000 net tons; Midwest, 193,000 net tons; South, 716,000 net tons; and West, 76,000 net tons, for a total of 1,861,000 tons. Production for the week increased in the Great Lakes and Midwest, but decreased in the North East, South and West.
The raw steel production tonnage provided in this report is estimated. The figures are compiled from weekly production tonnage from 50 percent of the domestic producers combined with monthly production data for the remainder. Therefore, this report should be used primarily to assess production trends. The AISI monthly production report provides a more detailed summary of steel production based on data supplied by companies representing 75 percent of U.S. production capacity.
Note, capability for fourth-quarter 2019 is approximately 30.4 million tons, compared to 30.8 million tons for the same period last year and 30.6 million tons for third-quarter 2019. Year-to-date totals are adjusted for consistency with monthly data.

Tim Triplett
Read more from Tim TriplettLatest in Steel Products Prices North America

Domestic plate prices could heat up despite so-so demand, market sources say
Some sources also speculated that plate could see further price increases thanks to modest but steady demand, lower imports, mill maintenance outages, and end markets less immediately affected by tariff-related disruptions.

SMU Price Ranges: HR holds, galv slips amid competing market narratives
SMU’s sheet and plate prices see-sawed this week as hot-rolled (HR) coil prices held their ground while prices for galvanized product slipped.

Nucor carries $875/ton HR list price into week seven
Nucor is keeping hot-rolled (HR) coil prices unchanged again this week, according to its latest consumer spot price (CSP) notice issued on Monday, Oct. 6

SMU Price Ranges: A newsy week sees modest price gains despite a quiet spot market
Market participants predicted that prices should be at or near a bottom. But while most seemed to agree on that point, many also said they saw little upside given a quiet spot market and ongoing concerns about demand.

Nucor increases plate prices by $60/ton
Nucor aims to increase prices for steel plate by $60 per short ton with the opening of its November order book.