Steel Products Prices North America
Weekly Raw Steel Production Remains at Low Levels
Written by Brett Linton
September 22, 2015
For the week ending September 19, 2015, the American Iron & Steel Institute (AISI) estimated the U.S. steel industry produced 1,706,000 net tons of raw steel, a 0.7 percent increase over the previous week but a 9.2 percent decrease over the same week one year ago. The estimated capacity utilization rate is 71.4 percent, up from 70.9 percent last week but down from 78.1 percent this time last year.
Estimated total raw steel produced for 2015 YTD is reported to be 64,357,000 tons, down 8.0 percent from the 69,987,000 tons produced during the same period in 2014. The average capacity utilization rate for 2015 YTD is estimated to be 72.5 percent, down from 78.0 percent for 2014 YTD.
Note that the total production capability figure for Q3 2015 is approximately 31.4 million tons versus 31.6 million tons for the same period last year and 30.7 million tons for the Q2 2015.
Week-over-week changes per district are as follows: Northeast at 211,000 tons, unchanged. Great Lakes at 621,000 tons, up 11,000 tons. Midwest at 218,000 tons, up 8,000 tons. South at 586,000 tons, up 13,000 tons. West at 70,000 tons, down 20,000 tons. Total production was 1,706,000 tons, up 12,000 tons.
SMU Note: Below is a graphic showing the weekly raw steel production history. To use the graphs interactive capabilities, you must view it on our website. You can do this by clicking here. If you need help navigating the website or need to know your login information, contact us at info@SteelMarketUpdate.com or by calling 800-432-3475.
Brett Linton
Read more from Brett LintonLatest in Steel Products Prices North America
September Import Share of US Sheet and Plate Markets
Imported sheet and plate products arrived at US ports at a slower clip in September, accounting for a lower share of the domestic market for the third straight month. That’s according to a Steel Market Update analysis of import data from the US Commerce Department and domestic shipment figures from the American Iron and Steel […]
US Apparent Steel Supply Falls Further in September
US apparent steel supply eased further in September, down 8% from August to 8.29 million net tons, according to data from the US Department of Commerce and the American Iron and Steel Institute (AISI). As the lowest monthly figure since February 2021, this was a 19-month low. September supply was 10% below the average monthly rate […]
Northwest Pipe Reports Sharply Higher Q3 Results
Engineered pipe and tube producer Northwest Pipe Co. posted sharply higher profits for the third quarter ended Sept. 30. The Vancouver, Wash.-based company said the boost was driven by strong demand and increasing backlogs from its engineered pipeline systems and precast products, according to earnings data released on Tuesday, Nov. 8 All told, Northwest Pipe posted net […]
SMU Price Ranges: Flat-Rolled Steel Falls (Yet Again)
Sheet prices fell across the board again this week as the slow grind lower that we’ve seen since last spring continued to gain speed. Hot-rolled coil prices fell $30 per ton ($1.50 per cwt) week-over-week. Declines in coated products were more pronounced, with cold rolled down $55 per ton, galvanized down $35 per ton, and […]
US Steel Exports Slip 10% in September
US steel export volumes shrunk 10% from August to September, according to the latest US Commerce Department data. 723,000 net tons of steel products exited the country during the month, now the fourth-lowest monthly export rate over the past year and a half. Recall that exports levels in August were at the third-highest monthly rate […]