Steel Products Prices North America

Regional Imports Through December: Hot-Dipped Galvanized Sheet
Written by Peter Wright
March 13, 2020
In 2019, imports of hot dipped galvanized sheet into the Great Lakes represented more than half the national total, and this was one of only two regions to experience an increase in 2019.
SMU presents a comprehensive series of import reports ranging from the first look at licensed data to the detailed look at volume by district of entry and source nation. The report you are reading now is designed to plug the gap between these two. National level import reports do a good job of measuring the overall market pressure caused by the imports of individual products. The downside is that there are huge regional differences. This report breaks total YTD import tonnage for each flat rolled product into seven regions and the growth/contraction for each region. Then it graphs the regional history of that product since 2013. We will report regional import data for each of six flat rolled products every other month. This month, we are reporting through December.
These six reports are intended to be reference documents with very few specific comments. The charts tell the whole story. Our intent is to provide buyers and sellers with an understanding of what is going on in their region of operation. Figure 1 shows the YTD tonnage of hot dipped galvanized sheet into each region and the huge variation between them. Figure 2 presents the same data as a pie chart. The region having by far the highest volume in 2019, YTD December, was the Great Lakes, which accounted for 51.3 percent of the total. There was minimal tonnage into both the Atlantic and Pacific coasts and the Rio Grande Valley.
Total hot dipped galvanized coil imports, YTD December, were down by 21.6 percent and decreased in all regions except the Great Lakes and Rio Grande. The Atlantic South was down by 62.0 percent.
Figure 3 shows the YTD change for each of seven regions and the change at the national level
Figures 4, 5, 6 and 7 show the history of hot dipped galvanized coil imports by region since March 2013 on a three-month moving average basis. Note, the Y axis scales are not the same.
Regions are compiled from the following districts (we will report on tonnage by district and source nation next month):
Atlantic North: Baltimore, Boston, New York, Ogdensburg, Philadelphia, Portland, St. Albans and Washington, DC.
Atlantic South: Charleston, Charlotte, Miami, Norfolk and Savannah.
Great Lakes: Buffalo, Chicago, Cleveland, Detroit, Duluth, Great Falls, Milwaukee, Minneapolis and Pembina.
Gulf: Houston, New Orleans, Mobile, San Juan, St. Louis and Tampa.
Pacific North: Anchorage, Columbia Snake, San Francisco and Seattle.
Pacific South: Los Angeles and San Diego.
Rio Grande Valley: Laredo and El Paso.

Peter Wright
Read more from Peter WrightLatest in Steel Products Prices North America

SMU price ranges: Flat-rolled balloon continues to leak
Sheet and plate prices were flat or lower again this week on continued concerns about demand and higher production rates among US mills.

HRC vs. busheling spread narrows in August
The price spread between prime scrap and hot-rolled coil (HRC) narrowed in August, according to SMU’s most recent pricing data.

SMU Price Ranges: Market drifts lower still
All five of SMU's steel sheet and plate price indices declined this week, falling to lows last seen in February.

Discontentment brews in plate market with flat, status-quo pricing
Sources in the carbon and alloy steel plate market said they are less discouraged by market uncertainty resulting from tariffs or foreign relations, but are instead, eager to see disruption to the flat pricing environment.

Nucor lowers HR coil spot price by $15/ton
Nucor has implemented a double-digit price decrease on spot hot-rolled (HR) coil for the second consecutive week.