Steel Products Prices North America
Wheeling-Nippon Steel Adjusts Most Galvanized Extras Lower
Written by Brett Linton
July 12, 2022
Wheeling-Nippon Steel made downward revisions to their galvanized coating extras on Tuesday, with new extras going into effect immediately.
Last week, Steel Dynamics and NLMK USA also revised their galvanized coating extras, with their new prices going into effect in August 2022. SMU provides an updated comparison of mill galvanized coating extras here in the Resources section of our website, comparing G30, G60 and G90 coating weights between 10 US mills. Detailed extras by individual mill are also available via the right-side navigation menu on that page.
SMU has analyzed the old and new extras below. Select Wheeling-Nippon extras decreased between 3-20%, with an average decrease of 13%. Wheeling-Nippon extras were previously revised in April 2022.
By Brett Linton, Brett@SteelMarketUpdate.com
Brett Linton
Read more from Brett LintonLatest in Steel Products Prices North America
CRU: Falling steel prices limit demand for imports into US
The recent decline in US hot-rolled (HR) coil and longs prices has further restricted demand for imported material. Despite the decline in US sheet prices, CR coil and HDG imports remain attractive. While demand for imports of longs products has been limited, buyers have increased imports of wire products to avoid wire rods’ higher tariffs. […]
Galvanized prices maintain big premium over HR
Prices for hot-rolled (HR) coil in recent weeks have been declining faster than those for galvanized sheet, resulting in a growing price spread between the two steel products.
SMU price ranges: Sheet down broadly, HR $35/t lower
Sheet prices fell across the board this week – largely in response to Nucor’s $65-per-short-ton price cut for hot-rolled (HR) coil on Monday morning. SMU’s HR coil price is $780/st on average, a $35/st decrease week over week (w/w). Our average cold-rolled coil price is $1,090/st (down $30/st w/w). Our galvanized base price is $1,100/st […]
Nucor surprises with $65/ton price drop for HRC
Nucor started off May with a bang, dropping its weekly base spot price for hot-rolled (HR) coil by $65 per short ton (st) this week.
Nucor drops weekly HR coil price by $10/ton
Nucor lowered its weekly base spot price for hot-rolled (HR) coil by $10 per short ton (st) this week.