Steel Products Prices North America
May Raw Steel Production Strong at 8.3 Million Tons
Written by Brett Linton
July 18, 2019
Total U.S. raw steel production in the month of May rose 2.7 percent to 8,325,489 net tons, reports the American Iron and Steel Institute in Washington. May production was at one of the higher levels in recent history, only surpassed by March 2019 and October 2018. Prior to those three months, the last time production topped that was in August 2014 at 8,546,303 tons.
Broken down by production method, 5,643,477 tons (67.8 percent) were produced by electric arc furnaces (EAFs) and 2,682,012 tons (32.2 percent) were produced by blast furnaces.
May production was 216,248 tons or 2.7 percent higher than April, and 319,400 tons or 4.0 percent higher than the same month one year ago. AISI’s monthly estimates are different than the weekly estimates SMU reports each Tuesday; the monthly estimates are based on over 75 percent of the domestic mills reporting versus only 50 percent reporting for the weekly estimates.
The mill capacity utilization rate for May averaged 80.8 percent, down from 81.3 percent in April, but up from 77.1 percent one year ago. The yearly capacity utilization rate has been adjusted down to 81.4 percent, up from 76.6 percent compared to the same five-month period last year.
The chart below shows total monthly steel production (blue) broken down by electric arc furnace production (green) and blast furnace production (red).
SMU Note: Interactive versions of the raw steel production graphics above can be seen in the Analysis section of our website here. If you need assistance logging into or navigating the website, contact us at info@SteelMarketUpdate.com.
Brett Linton
Read more from Brett LintonLatest in Steel Products Prices North America
Nucor holds HR price steady this week
Nucor is holding its hot-rolled (HR) coil consumer spot price (CSP) flat this week.
SMU price ranges: Sheet, plate largely unchanged
Sheet prices varied this week. While hot-rolled (HR) coil pricing was largely flat, cold-rolled (CR) coil and tandem product pricing eased slightly reflecting the momentum shift seen last week for HR coil. SMU’s average HR coil price was flat from last week at $835 per short ton (st) – potentially emphasizing the tension between competing […]
Nucor posts $830/ton spot HR price for week of April 8
Nucor said its spot hot-rolled (HR) coil price this week will be $830 per short ton (st).
US HR prices rebound, no longer near parity with imports
US hot-rolled coil and offshore hot band moved further away from parity this week as stateside prices have begun to move higher in response to mill increases.
Galvanized buyers report solid demand, balanced inventories
Galvanized buyers reported solid demand and balanced inventories this week and were anticipating the sheet price increase announced by Cleveland-Cliffs on Wednesday.