Steel Products Prices North America
U.S. Mill Capacity Utilization Nears 70 Percent
Written by David Schollaert
October 20, 2020
Raw steel production by U.S. mills rose again by 2.2 percent to 1,535,000 net tons in the week ending Oct. 17, continuing an uptrend that began nearly five months ago. The mill operating rate hit 69.4 percent, up from 67.9 percent the week prior. Despite the repeated rise in capacity utilization, production was still down by 15.0 percent compared with the same week last year, reported the American Iron and Steel Institute.
Adjusted year-to-date production through Oct. 17 totaled 62,481,00 net tons, at an average utilization rate of 66.3 percent. That is down 19.4 percent from the same period last year, when the utilization rate was 80.1 percent, AISA said.
Following is production by district for the Oct. 17 week: North East: 143,000 net tons; Great Lakes, 557,000 net tons; Midwest, 164,000 net tons; South, 601,000 net tons; and West, 70,000 net tons, for a total of 1,525,000 tons and a net increase of 23,000 tons. Despite nominal decreases in the North East and West regions, production was up across the other regions.
Note: The raw steel production tonnage provided in this report is estimated. The figures are compiled from weekly production tonnage from 50 percent of the domestic producers combined with monthly production data for the remainder. Therefore, this report should be used primarily to assess production trends. The AISI monthly production report provides a more detailed summary of steel production based on data supplied by companies representing 75 percent of U.S. production capacity. Capability for fourth-quarter 2020 is approximately 29.1 million tons, compared to 30.4 million tons for the same period last year and 29.4 million tons for the second quarter of 2020.
David Schollaert
Read more from David SchollaertLatest in Steel Products Prices North America
Nucor holds HR price steady this week
Nucor is holding its hot-rolled (HR) coil consumer spot price (CSP) flat this week.
SMU price ranges: Sheet, plate largely unchanged
Sheet prices varied this week. While hot-rolled (HR) coil pricing was largely flat, cold-rolled (CR) coil and tandem product pricing eased slightly reflecting the momentum shift seen last week for HR coil. SMU’s average HR coil price was flat from last week at $835 per short ton (st) – potentially emphasizing the tension between competing […]
Nucor posts $830/ton spot HR price for week of April 8
Nucor said its spot hot-rolled (HR) coil price this week will be $830 per short ton (st).
US HR prices rebound, no longer near parity with imports
US hot-rolled coil and offshore hot band moved further away from parity this week as stateside prices have begun to move higher in response to mill increases.
Galvanized buyers report solid demand, balanced inventories
Galvanized buyers reported solid demand and balanced inventories this week and were anticipating the sheet price increase announced by Cleveland-Cliffs on Wednesday.