Prices
Weekly Raw Steel Production Steady at 1.88 M Tons
Written by Brett Linton
June 23, 2014
For the week ending June 21, 2014, the American Iron & Steel Institute (AISI) reported that the U.S. steel industry produced 1,880,000 net tons (NT) of raw steel, a 1.6 percent increase over the previous week and a 3.1 percent increase over the same week one year ago. The estimated capacity utilization rate is 78.2 percent, up from 76.9 percent last week and up from 76.1 percent last year.
Estimated total raw steel produced for 2014 YTD is reported to be 45,115,000 tons, down 0.1 percent from the 45,163,000 tons produced through the same period in 2013. The average capacity utilization rate for 2014 YTD is estimated to be 76.4 percent, down from 76.7 percent for 2013 YTD. Note that there has been a change in production capability for 2014- comparisons between 2013 and 2014 capacity utilization rates are against different production levels, so the total tonnage figures are best suited for yearly comparisons.
Week-over-week changes per district are as follows: North East at 226,000 tons, down 3,000 tons. Great Lakes at 665,000 tons, up 17,000 tons. Midwest at 243,000 tons, down 3,000 tons. South at 657,000 tons, up 19,000 tons. West at 89,000 tons, unchanged. Total production was 1,880,000 tons, up 30,000 tons.
SMU Note: You can view the interactive graphic below when you are logged into the website and reading the newsletter online. If you have not logged into the website in the past and need a new user name and password we can do that for you out of our office. Contact us at: info@SteelMarketUpdate.com or by calling 800-432-3475. If you need help navigating the website we would also be very happy to assist you.
{amchart id=”84″ Weekly Raw Steel Production from AISI}
Brett Linton
Read more from Brett LintonLatest in Prices
SMU Survey: Mills less negotiable on spot prices
Most steel buyers responding to our market survey this week reported that domestic mills are considerably less willing to talk price on sheet and plate products than they were in recent weeks.
Price gap between US HRC, most imports narrows slightly
In dollar-per-ton terms, US product is on average $141/st less than landed import prices (inclusive of the 50% tariff). That’s down from $148/st last week.
SMU price ranges: Sheet ticks higher, plate stable
Sheet steel indices increased across the board this week, while plate prices held steady. All five of SMU’s price indices are higher than they were two weeks ago, and all but one are above levels recorded four weeks ago.
Nucor lifts HR spot price by $10/ton
Nucor has raised its weekly spot list price on hot-rolled coil by $10 per short ton (st) after keeping it unchanged since Aug. 25.
Atlas Tube up $50/ton following NLMK USA sheet price hike
Atlas Tube, in a leading move, said it aims to increase prices for mechanical tubing, hollow structural sections (HSS), and piling products by at least $50 per short ton (st).