Steel Products Prices North America

Correction: Galvanized G90 Mill Coating Extras Comparison
Written by Brett Linton
September 16, 2017
Last week, we mistakenly published new extras for Nucor that have not yet been announced. We have revised our galvanized coating extras comparison table (see below), which is also available on our website.
The table below is available on our website in the menu system under Resources > Steel Mills > Galvanized > Coating Extras Comparison. In that same Galvanized section, we have individual pages for each mill with their full coating, width and thickness extras listed, as well as their previous coating extras.

Brett Linton
Read more from Brett LintonLatest in Steel Products Prices North America

SMU Price Ranges: Sheet floor holds as market debates upside
Our average HR coil price increased $5/short ton from last week, marking a second consecutive week of modest gains. Market participants generally attributed the increase to...

Thin demand keeps plate prices hovering at lowest levels since February
Participants in the domestic plate market say spot prices appear to have hit the floor, and they continue to linger there. They say demand for steel remains thin, with plate products no exception.

SMU Price Ranges: HR crawls back to $800/ton
SMU’s HR price stands at $800/st on average, up $5/st from last week. The modest gain came as the low end of our range firmed, and despite the high end of our range declining slightly.

SMU successfully completes IOSCO review
SMU has successfully completed an external review of all our prices. The review has concluded that they algin with principles set by the International Organization of Securities Commissions (IOSCO).

Domestic plate prices could heat up despite so-so demand, market sources say
Some sources also speculated that plate could see further price increases thanks to modest but steady demand, lower imports, mill maintenance outages, and end markets less immediately affected by tariff-related disruptions.