Steel Products Prices North America

Regional Imports, Other Metallic Coated, Through June
Written by Peter Wright
August 12, 2019
Year to date, June, total other metallic coated imports (mainly Galvalume) were down by 11.8 percent, but the Pacific North was down by 71.8 percent and the Great Lakes region was up by 110.5 percent.
SMU now offers a comprehensive series of import reports ranging from the first look at licensed data to the very detailed look at volume by district of entry and source nation. The report you are reading now is designed to plug the gap between these two. Our intention is to report regional imports for six flat rolled products every other month. This month we are reporting through June.
National level import reports do a good job of measuring the overall market pressure caused by the imports of individual products. The downside is that there are huge regional differences, and we believe that buyers and sellers should have an understanding of regional differences. Figure 1 shows the year-to-date tonnage into each region and the huge variation between them. Figure 1a presents the same data as a pie chart.
Figure 2 shows the year-to-date change for each of seven regions and the change at the national level. Volume declined this year through June in four regions and increased in three regions.
Figures 3, 4, 5 and 6 show the history of OMC coil imports by region since March 2013 on a three-month moving average basis. Note, the Y axis scales are not the same.
Regions are compiled from the following districts (we will report on tonnage by district and source nation next month):
Atlantic North—Baltimore, Boston, New York, Ogdensburg, Philadelphia, Portland ME, St. Albans and Washington, D.C.
Atlantic South—Charleston, Charlotte, Miami, Norfolk and Savannah.
Great Lakes—Buffalo, Chicago, Cleveland, Detroit, Duluth, Great Falls, Milwaukee, Minneapolis and Pembina.
Gulf—Houston, New Orleans, Mobile, San Juan, St. Louis and Tampa.
Pacific North—Anchorage, Columbia Snake, San Francisco and Seattle.
Pacific South—Los Angeles and San Diego.
Rio Grande Valley—Laredo and El Paso.

Peter Wright
Read more from Peter WrightLatest in Steel Products Prices North America

Thin demand keeps plate prices hovering at lowest levels since February
Participants in the domestic plate market say spot prices appear to have hit the floor, and they continue to linger there. They say demand for steel remains thin, with plate products no exception.

SMU Price Ranges: HR crawls back to $800/ton
SMU’s HR price stands at $800/st on average, up $5/st from last week. The modest gain came as the low end of our range firmed, and despite the high end of our range declining slightly.

SMU successfully completes IOSCO review
SMU has successfully completed an external review of all our prices. The review has concluded that they algin with principles set by the International Organization of Securities Commissions (IOSCO).

Domestic plate prices could heat up despite so-so demand, market sources say
Some sources also speculated that plate could see further price increases thanks to modest but steady demand, lower imports, mill maintenance outages, and end markets less immediately affected by tariff-related disruptions.

SMU Price Ranges: HR holds, galv slips amid competing market narratives
SMU’s sheet and plate prices see-sawed this week as hot-rolled (HR) coil prices held their ground while prices for galvanized product slipped.