• Skip to main content

    Long Products

    AISI: Domestic steel production slips to four-month low

    Written by Brett Linton


    The volume of raw steel produced by US mills declined last week to the lowest rate recorded in over four months, according to recently released American Iron and Steel Institute (AISI) data. Domestic production has been historically strong for most of the year, recently touching a six-year high.

    Total raw steel output was estimated at 1,820,000 short tons (st) in the week ending August 8, a 50,000 st or 2.7% reduction from the prior week (Figure 1). Production is 3.2% higher than the same week of 2025.

    Brett Linton

    Read more from Brett Linton

    Latest in Long Products

    Imports fall back slightly in September, slide further in October

    Final import data for September from the US Commerce Department shows a slight decline from August’s 15-month high. And October’s license count suggests another month-on-month (m/m) decline in imports. September imports of 2,416,717 short tons (st) were down just 1% from 2,434,108 st in August, a 15-month high. October license data show a steeper 8% m/m fall to 2,214,730 st (Figure 1, left). August appears to have been the peak for the recovery in imports, which has been ongoing since February of this year, when we saw some of the lowest levels since 2020.

    Deacero casts first billet at new Ramos Arizpe mini-mill

    Mexican longs producer Deacero has cast the first billet at its new minimill in Ramos Arizpe, Mexico, moving the Danieli-supplied caster into commissioning. It's a key milestone for Deacero's $600-million Ramos II mini-mill, said Italian plant engineering and equipment provider. "The achievement further strengthens the long-standing collaboration between Deacero and Danieli, and further confirms Danieli’s already-established presence in the Mexican long-products market," the company said in a statement on Nov. 2.