• Skip to main content

    Analysis

    November 12, 2026

    Steel production suspended at Habas facility: source

    Written by Stephen Miller

    Steel production has been suspended at a facility of Turkish steelmaker Habas following a deadly explosion, a source told SMU.

    SMU spoke with a source in Turkey who provided some further information after the incident at the mill in Aliaga, Turkey, that occurred on Monday. (For background on the event, click here.)

    Stephen Miller

    Stephen Miller started his career in the scrap metal industry in 1978 at Luria Brothers in Cleveland. Over the last 40-plus years, he has worked in all capacities in the trading business. He has had positions in both domestic and international scrap trading. In addition to scrap, Miller was at the forefront of the pig iron trade and established a pig iron distribution company under the name of Ferrosource, Inc. Most recently, Miller has concentrated on the scrap export market and regularly does consulting for several companies in the industry.

    Read more from Stephen Miller

    Latest in Analysis

    Steel market chatter: Tight supply, strong demand keep sheet prices climbing

    In this week's Market Chatter, steel buyers point to tight supply and steady demand as reasons sheet prices could keep rising, with many expecting HRC to reach $1,400-1,449 per short ton in two months. Views on when the rally will peak are mixed, with some anticipating further increases while others mention softening demand and political uncertainty. Respondents also disagree on tariffs' impact. They say reshoring is generating activity but has yet to translate consistently into demand.

    Apparent steel supply remains historically high despite September dip

    The volume of finished steel that entered the US market eased 1% from August to September and held near a historically strong rate, according to SMU’s analysis of recently released Department of Commerce and American Iron and Steel Institute (AISI) data. Referred to as “apparent steel supply,” this measure is calculated by combining domestic mill shipments and finished US steel imports, then subtracting total US exports. It can be used as a proxy for domestic steel demand. Supply totaled 9.11 million short tons (st) in September, the fourth-highest rate recorded in the past four years. Supply has remained historically strong since May, when it surpassed the 9 million st mark for the first time in four years

    Imports fall back slightly in September, slide further in October

    Final import data for September from the US Commerce Department shows a slight decline from August’s 15-month high. And October’s license count suggests another month-on-month (m/m) decline in imports. September imports of 2,416,717 short tons (st) were down just 1% from 2,434,108 st in August, a 15-month high. October license data show a steeper 8% m/m fall to 2,214,730 st (Figure 1, left). August appears to have been the peak for the recovery in imports, which has been ongoing since February of this year, when we saw some of the lowest levels since 2020.

    Steel exports fall in September to lowest rate of the year

    US steel exports eased 3% from August to September, marking the third consecutive monthly decline following June’s 17-month high, according to recently released US Department of Commerce figures. Exports have been historically low since early 2025 and remain weak compared to volumes seen in prior years. In September, 615,000 short tons (st) of steel were shipped outside of the country, 2% below the average monthly export rate of the past twelve months. September trade was 3% higher than the same month of 2025, 19% lower than September 2024, 21% lower than September 2023, and 15% lower than September 2022. For context, exports fell to a five-year low of 469,000 st in December and reached a near-five-year high of 914,000 st in May 2023.