Steel Products Prices North America
Correction: Galvanized G90 Mill Coating Extras Comparison
Written by Brett Linton
September 16, 2017
Last week, we mistakenly published new extras for Nucor that have not yet been announced. We have revised our galvanized coating extras comparison table (see below), which is also available on our website.
The table below is available on our website in the menu system under Resources > Steel Mills > Galvanized > Coating Extras Comparison. In that same Galvanized section, we have individual pages for each mill with their full coating, width and thickness extras listed, as well as their previous coating extras.
Brett Linton
Read more from Brett LintonLatest in Steel Products Prices North America
Nucor holds HR price steady this week
Nucor is holding its hot-rolled (HR) coil consumer spot price (CSP) flat this week.
SMU price ranges: Sheet, plate largely unchanged
Sheet prices varied this week. While hot-rolled (HR) coil pricing was largely flat, cold-rolled (CR) coil and tandem product pricing eased slightly reflecting the momentum shift seen last week for HR coil. SMU’s average HR coil price was flat from last week at $835 per short ton (st) – potentially emphasizing the tension between competing […]
Nucor posts $830/ton spot HR price for week of April 8
Nucor said its spot hot-rolled (HR) coil price this week will be $830 per short ton (st).
US HR prices rebound, no longer near parity with imports
US hot-rolled coil and offshore hot band moved further away from parity this week as stateside prices have begun to move higher in response to mill increases.
Galvanized buyers report solid demand, balanced inventories
Galvanized buyers reported solid demand and balanced inventories this week and were anticipating the sheet price increase announced by Cleveland-Cliffs on Wednesday.