Prices
Weekly Raw Steel Production Below 1.8 Million Tons
Written by Brett Linton
July 20, 2015
For the week ending July 18, 2015, the American Iron & Steel Institute (AISI) estimated the U.S. steel industry produced 1,753,000 net tons of raw steel, a 0.7 percent increase over the previous week but a 8.4 percent decrease over the same week one year ago. The estimated capacity utilization rate is 73.3 percent, up from 72.8 percent last week but down from 79.6 percent last year.
Estimated total raw steel produced for 2015 YTD is reported to be 48,747,000 tons, down 7.7 percent from the 52,790,000 tons produced during the same period in 2014. The average capacity utilization rate for 2015 YTD is estimated to be 72.5 percent, down from 77.6 percent for 2014 YTD.
Note that the total production capability figure for Q3 2015 has been adjusted from Q2 2015, but the AISI did not specify these adjustments in their latest report. The Q2 2015 production figure was 30.7 million tons.
Week-over-week changes per district are as follows: Northeast at 225,000 tons, up 7,000 tons. Great Lakes at 623,000 tons, down 10,000 tons. Midwest at 208,000 tons, down 1,000 tons. South at 611,000 tons, up 14,000 tons. West at 86,000 tons, up 3,000 tons. Total production was 1,753,000 tons, up 13,000 tons.
SMU Note: Below is a graphic showing the weekly raw steel production history. To use the graphs interactive capabilities, you must view it on our website. You can do this by clicking here. If you need help navigating the website or need to know your login information, contact us at info@SteelMarketUpdate.com or by calling 800-432-3475.
Brett Linton
Read more from Brett LintonLatest in Prices
Final Thoughts
Most steel buyers think that steel prices will continue to rise into the 2026. But they don’t see the kinds of big gains that have characterized past market upturns, according to the results of SMU’s latest steel market survey.
SMU Survey: Mills less negotiable on spot prices
Most steel buyers responding to our market survey this week reported that domestic mills are considerably less willing to talk price on sheet and plate products than they were in recent weeks.
Price gap between US HRC, most imports narrows slightly
In dollar-per-ton terms, US product is on average $141/st less than landed import prices (inclusive of the 50% tariff). That’s down from $148/st last week.
SMU price ranges: Sheet ticks higher, plate stable
Sheet steel indices increased across the board this week, while plate prices held steady. All five of SMU’s price indices are higher than they were two weeks ago, and all but one are above levels recorded four weeks ago.
Nucor lifts HR spot price by $10/ton
Nucor has raised its weekly spot list price on hot-rolled coil by $10 per short ton (st) after keeping it unchanged since Aug. 25.