Prices

April Ferrous Scrap Prices: No Dramatic Shifts in Pricing Seen
Written by John Packard
March 23, 2017
Early indications (and we should put special emphasis on the word “early”) are for ferrous scrap prices to trend slightly lower on shred and obsolete grades while prime grades (busheling/bundles) are expected to trade sideways due to strong demand from sheet mills.
In March, prices for prime grades of scrap rose $60-$65 per gross ton while products such as heavy melt and shredded scrap were up by $40 per ton. One of the reasons for the increase in prime grades was due to Nucor’s DRI plant in Louisiana being down for a few weeks for repairs. SMU sources are advising the pig iron markets are also tight which puts upward pressure on prime grades.
Here is what we heard from one of our pig iron sources this morning, “The offers from little tonnage is still made in Northern Brazil are at about $380 – $385/mt CFR NOLA. The Ukraine production has been interrupted so the Russian pig iron offers probably are $385 – 390/mt CFR.”
As long as the price of prime ferrous scrap stays strong so will pig iron. It won’t slip with a scrap decline of $10-20, it would have to a longer steady decline. The Brazilians are probably sold out until June/July shipment.
Demand has been good at the domestic steel mills as witnessed with the better capacity utilization rates we have seen out of the AISI over the past couple of weeks.
One of our sources off the east coast had this to say about April scrap price expectations:
“It’s too early to peg where the April market will trade exactly. Demand is good, even better than last month, as evidenced by the improved operating rate, some bigger mill buy programs, and continued prime scrap tightness (DRI at Nucor is available again though pig iron is not) will keep prices somewhat steady. Deliveries to mills, especially from eastern yards, have been weak in March due to a lack of available railcars. But it will also be typical April market which means that dealers will not want to be holding much scrap at the end of April and better flows are probably coming soon (though not as good this year as is years past due to generally good weather this winter). In any event, I expect prime to trade sideways for the most part (no more $400++ deals though), and obsoletes to trade marginally weaker.”
John Packard
Read more from John PackardLatest in Prices
Price gap between US HRC, most imports narrows slightly
In dollar-per-ton terms, US product is on average $141/st less than landed import prices (inclusive of the 50% tariff). That’s down from $148/st last week.
SMU price ranges: Sheet ticks higher, plate stable
Sheet steel indices increased across the board this week, while plate prices held steady. All five of SMU’s price indices are higher than they were two weeks ago, and all but one are above levels recorded four weeks ago.
Nucor lifts HR spot price by $10/ton
Nucor has raised its weekly spot list price on hot-rolled coil by $10 per short ton (st) after keeping it unchanged since Aug. 25.
Atlas Tube up $50/ton following NLMK USA sheet price hike
Atlas Tube, in a leading move, said it aims to increase prices for mechanical tubing, hollow structural sections (HSS), and piling products by at least $50 per short ton (st).
Pig iron market quiet as US mills aim to outwait Brazilian suppliers
US buyers want to drop pig iron prices to levels commensurate with the decline in prime scrap in their domestic market. Prime price shed $20 per gross ton (gt) in September and another $20/gt in October.
