Steel Products Prices North America

Hot Rolled vs Plate Steel Prices: Plate Premium Rises to 46%
Written by Brett Linton
June 3, 2022
Sheet steel prices continue to decline from the March/April bump, while plate prices are easing at a slower rate, according to SMU’s price indices published last Tuesday. Plate prices typically carry a premium over hot rolled prices because plate is a value-added product and requires more time on the mill.
Hot rolled coil averaged $1,255 per ton ($62.75 per cwt) last week and has declined each of the past six weeks. Recall our index had reached a 14-month low of $1,000 per ton in the first week of March, following a record-high $1,955 per ton in September 2021. Our latest plate index averaged $1,830 per ton last week, declining each of the past three weeks. In that time, plate prices have declined $110 per ton from the $1,940 high seen on May 10. Plate prices have been much more stable compared to sheet prices, with our plate index remaining within $80 per ton of $1,880 for over eight months.
Throughout 2017 and the first half of 2018, plate prices held a roughly $100-per-ton premium over hot rolled. That premium crept up after mid-2018 to reach a high of $325 per ton by February 2019, declining thereafter until it diminished and hot rolled begain to sell at a higher price in October 2020. HRC held onto that premium until November 2021, losing it after sheet prices began declining in October and plate prices stood firm. The plate premium surged to $820 per ton in the first week of March of this year, quickly receding to $410 by the end of the month. For the past four weeks, plate has held a $575 per ton premium over hot rolled. The average premium held by plate over HRC for 2022 year-to-date is now $535 per ton.
To better compare this price spread, we graphed the plate price premium over hot rolled as a percentage of the hot rolled price. This is an attempt to paint a clearer comparison against historical pricing data. Plate prices held an average premium of 16% over hot rolled in 2017, peaking at a 56% premium in June 2019. The premium declined from there and turned negative in October 2020 (when HR began to sell at a higher price than plate), falling to a low of -17% in June 2021. Plate regained its premium price in November 2021, surging to a record high premium of 82% in the first week of March and falling to 29% by the end of the month. The latest plate premium is 46%, having risen each of the past nine weeks, and 2022 now averages 43% YTD.
By Brett Linton, Brett@SteelMarketUpdate.com

Brett Linton
Read more from Brett LintonLatest in Steel Products Prices North America

SMU Price Ranges: A newsy week sees modest price gains despite a quiet spot market
Market participants predicted that prices should be at or near a bottom. But while most seemed to agree on that point, many also said they saw little upside given a quiet spot market and ongoing concerns about demand.

Nucor increases plate prices by $60/ton
Nucor aims to increase prices for steel plate by $60 per short ton with the opening of its November order book.

Nucor’s $875/ton HR spot price spills into week six
Nucor is keeping hot-rolled (HR) coil prices unchanged again this week, according to its latest consumer spot price (CSP) notice issued on Monday, Sept. 29.

SMU Price Ranges: Sheet and plate flat or down as hopes of rebound meet ‘blah’ demand
Sheet and plate prices were flat or lower this week as less discounting from domestic mills was offset by few signs of an anticipated rebound in demand.

Price gap between US CR, most imports narrows
Cold-rolled (CR) coil prices ticked up in the US this week, matching a similar trend seen in offshore markets as well.