Final January steel import data was released this week, resting at 3.1 million net tons, according to the U.S. Department of Commerce. The last time a final monthly figure was this high was in April 2019 at 3.3 million tons. License data currently shows February imports at 1.8 million tons. As previously mentioned, the total […]
Imports of rolled products have declined every month since May 2018 year over year with the greatest declines in each month December 2019 through February 2020. Total rolled product imports in February were down by 26.7 percent on a three-month moving average (3MMA) basis. This follows the 26.3 percent decrease in December and 29.6 percent […]
In spite of the widely reported decline in import volume, import market share increased in the second quarter. Last week we reported that June was the eighth consecutive month in which imports were down by more than 20 percent compared to the same month last year. This has not been the case for import market […]
This report examines the import share of sheet, plate, long and tubular products and 16 subcategories. Since January 2020, imports’ share of the total sheet products has been 14.5 percent, down from 21.4 percent in 2015. The import share of HRC has been below 10 percent since January 2019. The most striking finding in this […]
AK Steel could be in danger of mill closures, said soon-to-be CEO Lourenco Goncalves, if stronger protection is not provided against electrical steel imports. In a warning to members of the Congressional Steel Caucus, Goncalves said the AK Steel mills in Butler, Pa., and Zanesville, Ohio, are unprofitable because of a loophole in the Section […]
Sheet prices in the U.S. Midwest market fell by $5-9 /s.ton, w/w with HR coil losing the most, assessed at $560 /s.ton. These prices reflect transactions from last week, which were primarily conducted ahead of recently announced mill price increases. While prices fell, the overall volume component fell at a faster rate. Until the price […]
Earlier this week the U.S. Court of Appeals for the Federal Circuit ruled against an appeal by the American Institute for International Steel challenging the constitutionality of the Section 232 tariffs. The court affirmed a ruling by the U.S. Court of International Trade, which upheld the Trump administration’s tariffs on imported steel. “While disappointed, we […]
The coronavirus has begun to affect business in the United States, according to the latest Federal Reserve “Beige Book.” The economy is moving forward at a modest to moderate pace, but growth is uneven. The virus appears to be negatively impacting travel and tourism in the U.S., which showed only moderate to flat growth in […]
By CRU Chief Economist Jumana Saleheen, from CRU’s Steel Sheet Products Market Outlook Two pieces of news have led us to lower our global forecasts for 2020. First, disruptions caused by the Covid-19 epidemic are expected to lead to a sharp downturn in near-term global growth, followed by a sharp recovery later in the year. […]
Lourenco Goncalves is well known for speaking his mind. As an unconventional thinker and investor, he has put himself, and his company, at the center of the changes that are transforming the steel industry—and not for the first time in his career. The Chairman, President and CEO of Cleveland-Cliffs, Inc., will be a keynote speaker […]
The American Institute for International Steel suffered another setback in its constitutional challenge of the Trump administration’s use of Section 232 tariffs to restrict steel and aluminum imports on the basis of national security. In a ruling on Friday, the U.S. Court of Appeals rejected the claim by AIIS that the “non-delegation doctrine” makes it […]
Trade attorney and Steel Market Update contributor Lewis Leibowitz offers the following update on events in Washington: As a participant of long standing in the saga of international trade cases, I can say that this week was particularly interesting. First, the U.S. International Trade Commission did something unusual—last Tuesday, it made a final negative determination […]
Preliminary Census data for January steel imports was released this week, totaling just over 3.1 million net tons for the month, according to the U.S. Department of Commerce. While the January license data is still preliminary, the last time the final Census data was this high was in April 2019 at 3.3 million tons. The […]
The U.S. International Trade Commission rejected antidumping and countervailing duties for fabricated structural steel from Canada, China and Mexico. The USITC found that the U.S. industry is not materially injured or threatened by imports of the products from the three countries after a Commerce investigation determined that China and Mexico were subsidizing the products and […]
By CRU Prices Analyst Estelle Tran, from CRU’s Global Steel Trade Service The impact of the U.S. International Trade Commission’s surprising negative determination that allegedly dumped and subsidized fabricated structural steel imports from China, Canada and Mexico have not materially injured a U.S. industry is tough to define in the current protectionist environment. Preliminary tariffs […]
Domestic mills won back market share from imports in 2017, 2018 and 2019. Even though the steel market contracted by 1.9 percent in 2019, shipments by U.S. mills to domestic locations increased by 2.9 percent as imports declined. Table 1 shows 13 years of history of total steel supply to the U.S. market in short […]
Written by: John Packard, President & CEO, Steel Market Update Steel prices in general appear to have weakened further for the fifth week, based on Steel Market Update’s canvass of the market over the past two days. Hindsight being 20/20, SMU arguably could have adjusted its Price Momentum Indicator from Neutral to Lower earlier than […]
Licenses for imports of finished steel in January totaled around 1.7 million tons, according to the latest Department of Commerce data, well above the three-month moving average near 1.4 million tons. While the January license data is prelminary, the last time the final Census data for finished imports was this high was in August 2019 […]
The following article discussing the global ferrous derivatives markets was written by David Feldstein. As an independent steel market analyst, advisor and trader, we believe he provides insightful commentary and trading ideas to our readers. Note that Steel Market Update does not take any positions on HRC or scrap trading, and any recommendations or comments […]
By CRU Senior Analyst Helen O’Cleary, from CRU’s Zinc Monitor Disruption caused by the Covid-19 outbreak has cut Chinese demand and visible stocks have risen sharply, placing downward pressure on prices. In Hubei, where restrictions on the movement of goods and people was due to be lifted tomorrow, the local government has just announced today […]
While America’s integrated steel producers are investing millions in R&D to reduce harmful emissions from their steelmaking process, the nation’s minimill steel producers have already claimed the high ground for environmental stewardship. Integrated mills and their blast furnaces heat iron ore and coking coal at high temperatures to produce high-quality virgin pig iron and steel. […]
In this report we examine the change in currency values of the 16 pre-eminent global steel and iron ore trading nations. The U.S. dollar has strengthened against 10 of the 16 currencies in the last three months. In January we replaced the British pound in this report with the Vietnamese dong in recognition that Vietnam […]
In three months through December, demand for total rolled products declined by 6.1 percent. This Premium analysis by Steel Market Update is based on steel mill shipment data from the American Iron and Steel Institute (AISI) and import-export data from the U.S. Department of Commerce (DOC). It is meant as a more in-depth look compared […]
This report examines the import share of sheet, plate, long and tubular products and 16 subcategories. Since January 2019, the import market share of total sheet products has been below 15 percent with an 11-month average of 14.0 percent. The import share of HRC has been below 10 percent since January 2019. The most striking […]
Steel prices finished 2019 on an upward trajectory, giving the market hope for a stronger 2020. That trend proved short-lived, however, as prices stalled in January and February, leaving both buyers and sellers wondering what to expect in the weeks and months ahead. Steel prices rose in November and December on a series of price […]
Trade attorney and Steel Market Update contributor Lewis Leibowitz offers the following update on events in Washington: First, I want to recap the World Trade Organization crisis. The Trump administration has put a big obstacle in the way of WTO dispute settlement by refusing to permit new members of the “supreme court” of the WTO […]
Trade attorney and Steel Market Update contributor Lewis Leibowitz offers the following update on events in Washington: I received a question recently about the significance of Section 321 of the Tariff Act of 1930. Section 321 exempts imports from duties if they have an entered value of less than $800 per entry and meet certain […]
The office of the U.S. Trade Representative released a scathing report detailing what the U.S. believes is wrong with the dispute mechanisms of the World Trade Organization. In 174 pages, the department lays out the alleged failures of the Appellate Body to conduct business by “agreed rules.” “As detailed in this Report, the Appellate Body […]
Members of the New Democrat Coalition Trade Task Force are outraged that the report for the Section 232 investigation into auto imports has not been released and that the threat of tariffs continues to create economic uncertainty. The results of the investigation were submitted to President Trump in February 2019, but the report was never […]
Apparent U.S. steel supply increased to 8.8 million net tons in December, according to data from the American Iron and Steel Institute and U.S. Department of Commerce. While up over the previous three months, December supply remains low compared to the last two years. Last month we reported that November supply was at a three-year low, […]