Steel Products Prices North America

January Raw Steel Production at 8.08 Million Net Tons
Written by Brett Linton
March 3, 2014
The American Iron & Steel Institute (AISI) reported their final raw steel production numbers for the month of January 2014. This estimation is different than the weekly raw steel production as it is based on 75 percent of the domestic mills reporting vs. 50 percent for the weekly estimates.
Total raw steel production for the month of January was reported to be 8,078,550 net tons (NT) with 5,127,357 NT being produced by electric arc furnaces (EAF) and 2,951,193 NT produced by blast furnaces. January raw steel production was reported by the AISI to have been 2.9 percent higher than the previous month.
Total raw steel production for 2014 so far is 0.5 percent below that of 2013 through the same time period. The capacity utilization rate for the month of January was reported to be 75.8 percent. (Source: AISI)
Below is a chart showing the monthly production figures in a 3-month moving average.

Brett Linton
Read more from Brett LintonLatest in Steel Products Prices North America

HRC vs. prime scrap spread widens in June
The price spread between HRC and prime scrap widened in June.

SMU price ranges: Steel prices rise in response to tariffs
Steel prices climbed for a second straight week across all five sheet and plate products tracked by SMU.

Nucor lifts list price for spot HRC by $20/ton
The $20/short ton increase applies to all of the steelmaker’s sheet mills, including West Coast joint-venture subsidiary CSI.

Nucor pauses month-long slide in weekly HR price
Nucor halted a four-week decline in its spot price for hot-rolled coil this week, maintaining its weekly consumer spot price (CSP) at $870/st.

Nucor lowers HRC by $10/ton in fourth straight cut
Nucor has lowered its consumer spot price (CSP) for hot-rolled coil by $10 per short ton (st), marking the fourth consecutive weekly decrease.