Steel Products Prices North America

June Apparent Steel Supply Climbs to 17-Month High
Written by Brett Linton
August 11, 2021
June apparent steel supply rose 270,000 tons over May to 9.38 million net tons, according to the latest U.S. Department of Commerce and American Iron and Steel Institute data. This is the highest suppy level seen since January 2020, surpassing the May 2021 recent-high of 9.11 million tons. June supply is up by 2.47 million tons compared to the same month in 2020 (recall that April and May of 2020 were the two lowest levels seen in the last 10 years).
Apparent steel supply, a proxy for demand, is determined by combining domestic steel mill shipments and finished U.S. steel imports, then deducting total U.S. steel exports.
June apparent supply increased 35.7% compared to the same month one year ago, when supply was 6.92 million tons. This increase was primarily due to an increase in domestic shipments of 2.01 million tons, followed by a 794,000-ton increase in finished imports, slightly negated by a 332,000-ton increase in exports. The net trade balance between U.S. steel imports and exports rose to a surplus of 2.15 million tons imported in June, up 124.1% from one year prior. Finished steel imports accounted for 22.7% of apparent steel supply in June, up from 19.3% one year ago.
Compared to May when apparent supply was 9.11 million tons, June supply rose by 273,000 tons or 3.0%. This increase was due to a 265,000-ton increase in finished imports and a 44,000-ton increase in domestic shipments, partially negated by a 36,000-ton increase in exports. The net trade balance between imports and exports in June rose 20.8% from May, and the percentage of apparent steel supply composed of finished steel imports increased 2.2% month-over-month.
The figure below shows year-to-date averages for each statistic over the last five years. The 2021 apparent supply average has now surpassed the 2020 averages, but remains significantly lower compared to the monthly averages of all previous years shown.
To see an interactive graphic of our Apparent Steel Supply history (example shown below), visit the Apparent Steel Supply page in the Analysis section of the SMU website. If you need any assistance logging into or navigating the website, contact us at info@SteelMarketUpdate.com.
By Brett Linton, Brett@SteelMarketUpdate.com

Brett Linton
Read more from Brett LintonLatest in Steel Products Prices North America

HRC vs. prime scrap spread widens in June
The price spread between HRC and prime scrap widened in June.

SMU price ranges: Steel prices rise in response to tariffs
Steel prices climbed for a second straight week across all five sheet and plate products tracked by SMU.

Nucor lifts list price for spot HRC by $20/ton
The $20/short ton increase applies to all of the steelmaker’s sheet mills, including West Coast joint-venture subsidiary CSI.

Nucor pauses month-long slide in weekly HR price
Nucor halted a four-week decline in its spot price for hot-rolled coil this week, maintaining its weekly consumer spot price (CSP) at $870/st.

Nucor lowers HRC by $10/ton in fourth straight cut
Nucor has lowered its consumer spot price (CSP) for hot-rolled coil by $10 per short ton (st), marking the fourth consecutive weekly decrease.