Steel Products Prices North America

Regional Imports Through October: Cold Rolled Coil
Written by Peter Wright
December 13, 2019
Steel Market Update offers a comprehensive series of import reports ranging from the first look at licensed data to the very detailed look at volume by district of entry and source nation. The report you are reading now is designed to plug the gap between those two. National level import reports do a good job of measuring the overall market pressure caused by the imports of individual products. The downside is that there are huge regional differences. This report breaks total YTD import tonnage for each flat rolled product into regions and the growth/contraction for each region. Then it graphs the regional history of that product over a six-year period. We will report regional import data for each of six flat rolled products every other month.
This report breaks total YTD import tonnage for each flat rolled product into regions and the growth/contraction for each region. Then it graphs the regional history of that product over a six-year period. We will report regional import data for each of six flat rolled products every other month. This month, we are reporting through October. These six reports are intended to be reference documents with very few specific comments. The charts tell the whole story. Our intent is to provide buyers and sellers with an understanding of what is going on in their region of operation. Figure 1 shows the year-to-date tonnage into each region and the huge variation between them. Figure 1a presents the same data as a pie chart. By far the highest volume region in 2019 YTD October was the Great Lakes. The Pacific North and Atlantic South received minimal tonnage.
Year to date through October, total cold rolled coil imports were down by 20.4 percent and decreased in all regions except the Rio Grande. The Gulf region was down by 48.5 percent and the Rio Grande was up by 2.9 percent.
Figure 2 shows the year-to-date change for each of seven regions and the change at the national level
Figures 3, 4, 5 and 6 show the history of cold rolled coil imports by region since March 2013 on a three-month moving average basis. Note, the Y axis scales are not the same.
Regions are compiled from the following districts (we will report on tonnage by district and source nation next month):
Atlantic North—Baltimore, Boston, New York, Ogdensburg, Philadelphia, Portland ME, St. Albans and Washington, D.C.
Atlantic South—Charleston, Charlotte, Miami, Norfolk and Savannah.
Great Lakes—Buffalo, Chicago, Cleveland, Detroit, Duluth, Great Falls, Milwaukee, Minneapolis and Pembina.
Gulf—Houston, New Orleans, Mobile, San Juan, St. Louis and Tampa.
Pacific North—Anchorage, Columbia Snake, San Francisco and Seattle.
Pacific South—Los Angeles and San Diego.
Rio Grande Valley—Laredo and El Paso.

Peter Wright
Read more from Peter WrightLatest in Steel Products Prices North America

SMU Price Ranges: Some predict bottom is near as big discounts dry up
Sheet prices were mixed this week as some mills continued to offer significant discounts to larger buyers while others have shifted toward being more disciplined, market participants said.

SMU Price Ranges: Tags mixed as uncertainty weighs on market
SMU’s hot-rolled (HR) coil price held steady this week while prices for other sheet and plate products declined.

Nucor spot HR list price unchanged at $875/ton
Nucor kept its weekly list price for hot-rolled (HR) coil unchanged this week, following a price bump of $10 per short ton (st) last week.

SMU price ranges: Flat-rolled balloon continues to leak
Sheet and plate prices were flat or lower again this week on continued concerns about demand and higher production rates among US mills.

HRC vs. busheling spread narrows in August
The price spread between prime scrap and hot-rolled coil (HRC) narrowed in August, according to SMU’s most recent pricing data.