Features
AISI: Raw steel output slips back down
Written by David Schollaert
March 18, 2024
Domestic production of raw steel moved lower last week, slipping back down after recovering the week prior, according to the most recent data from the American Iron and Steel Institute (AISI).
Steel output in the US totaled an estimated 1,714,000 short tons (st) in the week ended March 16. That’s down 1.2% from the previous week and down 0.2% from the same week last year when production stood at 1,718,000 st.
The mill capability utilization rate was 77.2% in the week ended March 16, down from 78.1% a week earlier and from 76.9% a year ago.
Year-to-date production through March 17 was 18,307,000 st at a capability utilization rate of 75.9%. That was off 3.1% from 18,886,000 st in the same period a year earlier when capability utilization was 77.7%.
Production by region is shown below, with the week-over-week changes shown in parentheses:
- Northeast – 134,000 st (down 3,000 st)
- Great Lakes – 580,000 st (down 6,000 st)
- Midwest – 181,000 st (down 4,000 st)
- South – 760,000 st (down 2,000 st)
- West – 59,000 st (down 5,000 st)
Editor’s note: The raw steel production tonnage provided in this report is estimated. The figures are compiled from weekly production tonnage provided by approximately 50% of the domestic production capacity combined with the most recent monthly production data for the remainder. Therefore, this report should be used primarily to assess production trends. The AISI production report “AIS 7”, published monthly and available by subscription, provides a more detailed summary of steel production based on data supplied by companies representing 75% of U.S. production capacity.
David Schollaert
Read more from David SchollaertLatest in Features
Final Thoughts
I’m trying to make sure this is not a TL;DR Final Thoughts. As a journalism school professor once told me, ‘No one but your mom reads more than 1,000 words.’ Also, as the old adage goes, a picture is worth a thousand as well. With that in mind, below are a couple of charts that I think go a long way toward explaining how prices and lead times have been relatively stable despite concerns about demand.
SMU survey: Mill lead times stretch out marginally
Steel mill lead times inched up this week for most sheet and plate products, according to buyers responding to our latest market survey.
SMU survey: Mills remain open to negotiate prices, most buyers say
Negotiation rates have consistently been in the 70-80% range for over two months, relatively strong in comparison to levels seen across the past year.
Former AK Steel headquarters are up for sale
The building that was once the headquarters of AK Steel is again up for sale.
Final Thoughts
It’s another week of big headlines for the world writ large – an expanding war in the Middle East, another potentially catastrophic hurricane – and not much going on in the world of steel prices. “Call me Stevie Wonder, I see nothing.” That’s how one service center executive described the current sheet market. There seems to be almost a competition among some of our Community Chat guests and contributors to outdo each other in flowery ways to say, “