SMU Data and Models
SMU survey: Sheet buyers find mills more willing to negotiate spot prices
Written by Ethan Bernard
April 25, 2024
Sheet steel buyers said mills are more willing to talk price on spot orders, according to our most recent survey data.
However, plate buyers found mills less willing to negotiate this week, with 71% of respondents saying mills were flexible on price vs. 79% two weeks earlier.
Every other week, SMU polls steel buyers asking if domestic mills are willing to negotiate lower spot pricing on new orders.
This week, 75% of participants surveyed by SMU reported mills were willing to negotiate prices on new spot orders. This is up three percentage points from 72% at our last market check. The end of March, with a reading of 49%, marks the only time the rate has dipped below 50% in 2024 (Figure 1).
Figure 2 below shows negotiation rates by product. The rates for hot-rolled coil rose six percentage points to 79% this week. Cold rolled was 64% (+2). Galvanized stood at 75% (+3). And Galvalume was 100% (+25).
Here’s what some survey respondents had to say:
“Depends on the tonnage (for plate). Over 1,000 tons, yes.”
“Have seen less willingness to negotiate (on HRC) this week compared to last week.”
“Depends on your stature and tons (for HRC).”
“Depends on your stature, tons, and mill (for plate).”
Note: SMU surveys active steel buyers every two weeks to gauge their steel suppliers’ willingness to negotiate pricing. The results reflect current steel demand and changing spot pricing trends. SMU provides our members with a number of ways to interact with current and historical data. To see an interactive history of our steel mill negotiations data, visit our website.
Ethan Bernard
Read more from Ethan BernardLatest in SMU Data and Models
SMU market survey results now available
The latest SMU market survey results are now available on our website to all premium members. After logging in at steelmarketupdate.com, visit the pricing and analysis tab and look under the “survey results” section for “latest survey results.” Historical survey results are also available under that selection. If you need help accessing the survey results, or if […]
SMU survey: Buyers’ Sentiment finishes April on the upswing
SMU’s Steel Buyers’ Sentiment Indices both rose this week to reach some of the highest levels seen this year.
SMU survey: HR, plate lead times slip as CR extends
Hot-rolled coil and plate lead times contracted this week, with most other products remaining flat, according to SMU's most recent survey data. Cold-rolled products, however, saw lead times extend 0.1 weeks to an average of 7.5 weeks vs. two weeks earlier. Hot rolled and plate lead times both contracted 0.3 weeks from our last market check.
Steelmaking raw material prices mixed in April
Prices of steelmaking raw materials have moved in different directions over the last 30 days, according to Steel Market Update’s latest analysis.