Shipping delays of iron ore on the Great Lakes are finally over. Ice coverage on the Great Lakes is down to 9.1 percent with the remaining ice concentrated in Lake Superior. According to satellite imagery, about 22 percent of Superior is still covered. The US Coast Guard reports there are still small fields of ice […]
For the week ending May 10, 2014, the American Iron & Steel Institute (AISI) reported that the U.S. steel industry produced 1,843,000 net tons (NT) of raw steel, a 1.5 percent increase over the previous week and a 0.5 percent increase over the same week one year ago. The estimated capacity utilization rate is 76.6 […]
Steel Market Update watches foreign steel imports as closely as humanly possible as we look for trends to see how imported steel tonnages relate to past historical averages. We use a monthly average as opposed to a specific monthly number in order to smooth out the numbers and provide a clearer picture. As you can […]
Steel Market Update was the big mover of hot rolled prices this week as we took our average to $685 per ton or $10 per ton higher than one week ago. CRU, Platts and SteelBenchmarker all held their numbers as is for the week. The hot rolled indexes average is up $5 per ton to […]
Shredded scrap prices were still volatile in some markets as it searched for a bottom in the Ohio Valley and elsewhere at the end of last week. Detroit was reported to be the first market to settle with the mills there paying $15 per gross ton less than the prior month paying approximately $380 per […]
Apparent steel supply for March was 9,753,954 net tons, a 9.6 percent increase compared to the same month one year ago. This is due to an increase in domestic shipments and finished imports and a slight decrease in total US exports. The net trade balance between imports and exports was a surplus of 2,194,246 net […]
March ferrous scrap exports totaled 1,466,528 net tons (1,330,413 metric tons) with Turkey, Taiwan, Korea, Egypt, and Mexico the top five countries receiving U.S. scrap. These countries received 69.3 percent of all scrap exports. Total March ferrous scrap exports were 11.1 percent higher than previous month but 32.3 percent lower than the same month one […]
Apparent supply is defined as domestic mill shipments to domestic locations plus imports. Sources are the American Iron and Steel Institute and the Department of Commerce. The three month moving average of the total tonnage of sheet and strip supply in the 1st quarter was 4,603,548 tons, up from 4,426,649 tons per month in Q4 […]
The hot rolled coil (HRC) futures market has been trading sideways over the past couple of weeks, taking cues from the physical market that looks to have slowed its ascent. Trading volumes have been fairly average, with traders and hedgers seemingly more comfortable on the sidelines until a new catalyst sparks the market to break […]
The following is reprinted from AIIS March Export Press Release: March Important Canadian and Mexican Markets Show Strong Gains U.S. steel exports expanded significantly in March, though they remained below the levels of a year earlier. Following a dip in February, when many parts of the United States were still suffering the impact of a […]
Iron ore smuggling has become a concern of the Mexican government with the diversification of the Knights Templar drug cartel into mining operations in the western state of Michoacán. Mexican authorities have seized nearly 200,000 tons of illegally mined and shipped iron ore headed for China so far this year. Last week a ship was […]
Pressure continues on flat rolled steel prices as we saw gains on hot rolled and cold rolled while galvanized and Galvalume remained the same as one week ago. The issue on the coated products and cold rolled to a lesser degree, has been imported steel which is impacting the southern states in two ways. First, […]
When Nucor announced their earnings on April 24th they held a conference call with analysts to discuss their business and to make statements about their company, the markets they serve and about the economy in general. John Ferriola, Nucor’s Chairman, CEO and President, provided an opening statement during which he made the following remarks regarding […]
For the week ending May 3, 2014, the American Iron & Steel Institute (AISI) reported that the U.S. steel industry produced 1,815,000 net tons (NT) of raw steel, a 1.1 percent decrease over the previous week and a 1.1 percent decrease over the same week one year ago. The estimated capacity utilization rate is 75.5 […]
This past week three of the four flat rolled steel price indexes followed by Steel Market Update (SMU) reported only modest gains in benchmark hot rolled pricing with SMU being the most conservative holding our pricing at the same levels as we had reported the prior week. Platts was the one exception as their hot […]
Steel Market Update follows a number of price indices on a weekly basis. All of the indices saw double digit increases during the month of April. The average change on hot rolled was +$43 per ton, cold rolled +$47 per ton, galvanized +$66 per ton and Galvalume +65 per ton. Plate prices remained relatively stable […]
Shredded ferrous scrap prices are now projected to be down $15 to $20 per gross ton in the Chicago market according to SMU sources. At the same time prime grades (like #1 busheling) are expected to tread sideways (remain the same as prior month). If, once the deals are completed, all runs true to the […]
The following chart is based on price variances from the end of March until the most recent numbers produced at the end of April. All commodities saw price increases with the exception of iron ore which was down quite dramatically (China spot market).
Based on revised domestic and world export pricing on hot rolled coil (SteelBenchmarker), the price spread between the two continues to grow. As you can see by the graphic shown below, the spread has been widening ever since domestic steel production issues began impacting flat rolled steel pricing in the U.S. and Canada. The spread […]
Iron ore prices continue to boil and bubble, with the key word being bubble. At the beginning of April, 62% Fe fines were trading at $117 per dry metric ton (dmt). They peaked nine days later at $119.4/dmt and since then the air has been leaking out of the bubble. On Wednesday, iron ore prices […]
According to the American Iron and Steel Institute (AISI) domestic raw steel production totaled 8,273,082 net tons (all products). Of the total 60 percent was produced by electric arc furnaces and the balance by blast/BOF furnaces. Carbon steel products totaled 7,681,790 net tons with 4,665,056 tons being produced by EAF’s and the balance, 3,016,734 tons […]
Financial Markets We are still in the testing of the highs mode, closing in the 1877.50 zone on S+P 500, not much different from a week back. Need to take the out the old high and test 1900 again, otherwise… The Fed tapered on the easing, paring the buying program back $10 bln /month again–think […]
This article is part of a longer article first published on Thursday, May 1st and is written by Andre Marshall, CEO of Crunchrisk, LLC and our Managing Price Risk II instructor: Steel It was a fairly quiet week in futures with 400 lots or 8,000 ST trading most of yesterday on the July date. […]
Iron ore prices continue to boil and bubble, with the key word being bubble. At the beginning of April, 62% Fe fines were trading at $117 per dry metric ton (dmt). They peaked nine days later at $119.4/dmt and since then the air has been leaking out of the bubble. On Wednesday, iron ore prices […]
Today is the 3rd of April and negotiations between the steel mills and their scrap suppliers continue in earnest. We heard from one of our sources that Detroit has settled up $10 per gross ton. Our source reported #1 Heavy Melt (HMS) at $365-$370 per gross ton, shredded scrap at $395-$400 per gross ton and […]
Steel Market Update is aware that many buyers and sellers of steel have been keyed in on the variations between various flat rolled steel indexes. In the past, Steel Market Update found the spread between our steel index and those of Platts and CRU to generally be negligible ($1-$10 per ton at any one time). […]
Each week during the month Steel Market Update (SMU) checks the license data from the U.S. Department of Commerce regarding imports of foreign steel. Based on the data compiled each week we then project where we think imports will end up at the end of the month. April license data is suggesting we could see […]
Steel Market Update continuously is in conversation with flat rolled steel buyers from around the country. We have noticed a growing nervousness within the steel community as the buyers grapple with ever higher steel prices and extended lead times. In some cases the lead times on foreign material are not much more than what the […]
Prices moved sideways this week as buyers digest the $30 per ton of movement made in benchmark hot rolled pricing going back to the beginning of the month of April. Steel Market Update is aware there are a number of domestic mills who have made “internal” spot price adjustments, taking price offers from $34.25/cwt ($685 […]
Each week during the month Steel Market Update (SMU) checks the license data from the U.S. Department of Commerce regarding imports of foreign steel. Based on the data compiled each week we then project where we think imports will end up at the end of the month. April license data is suggesting we could see […]