Steel Products
Imports Return to Pre-Recession Levels
Written by John Packard
January 2, 2013
Based on total projected imports of 33,512,516 net tons for calendar year 2012, imports for this year will be at the highest level since the recession began. The last year imports exceeded what we are projecting based on US DOC license data through December, was 2006 when the U.S. received 45,273,023 net tons.
Based on recently released preliminary census data for the month of November along with updated license data for December we have a better idea regarding what imports will look like for each of these months. Both will be close to the moving 3-month moving average of 2.627 million net tons. November is projected to be 2,659,486 net tons and our early forecast is for December to be a little lower at 2,560,480 net tons.
What is sticking out like a sore thumb is the amount of semi-finished (see next article).
As you can see by the table above, hot rolled imports during November are slightly below both the 3-month and 12-month moving average while December projections are slightly above both the 3MMA and 12MMA.
Cold Rolled imports are above both the 3-month and 12-month moving average in November and December.
Galvanized imports for November were above the 3-month and 12-month moving average while the projected December number is, at this moment, below both.
Galvalume/Aluminized imports for both November and December are within a few thousand tons of the averages.
John Packard
Read more from John PackardLatest in Steel Products
US rig count slips, Canada ticks higher
ncreases through September, according to the latest Baker Hughes rig count data.
CRU: EC to toughen steel safeguards
The European Commission proposes cutting its steel import quota by almost half, with volumes exceeding the limit facing 50% duties. The region’s steel industry welcomes the move, while other steel-producing nations fear the consequences. CRU published an insight before this announcement, noting that more restrictive trade policy could significantly raise the cost of marginal supply […]
US and Canadian rig counts stabilize
US counts continue to hover just above historic lows, while Canadian figures remain comparatively healthy.
Plate market sources critique mill hikes amid current market conditions
Following spot market plate price increase notices issued by domestic mills this past week, participants are contemplating the rationale behind the increases and whether they will stick. Some sources anticipate that current market conditions will shift in November and believe the increases may set a new "pricing floor."
Oregon Steel Mills lifts plate prices by $60/ton
Oregon Steel Mills has joined other producers in announcing a price increase of at least $60 per short ton on steel plate.