For the week ending August 31, 2013, the American Iron & Steel Institute (AISI) reported that the U.S. steel industry produced 1,856,000 net tons of raw steel, a 0.3 percent decrease over the previous week and a 2.2 decrease over the same week one year ago. The estimated capacity utilization rate is 77.5 percent, down […]
SMU was speaking with one of the steel mills this morning who was lamenting about the drop in spot galvanized base prices from the $37.50/cwt level to down around $36.00/cwt base prices. Two conversion mills were mentioned as being the culprits leading the charge. Not everyone (yet) is participating but this mill executive thought it […]
We are starting to spot slight gyrations in the other indexes that we monitor on a regular basis. Most of the items reported this past week were unchanged from the week prior. It is important to remember there are differences in both the collection techniques of the various indexes as well as different FOB […]
Financial Markets: Since last week’s writing the SP 500 has since rallied to test the old support above at 1670 to then fail and drop to 1627 before rebounding in the last two days to 1642. As I mentioned, we are likely in a retracement move down to the 1550 target before we can find […]
The American Iron & Steel Institute (AISI) reported their final raw steel production numbers for the month of July 2013. This estimation is different than the weekly raw steel production as it is based on 75 percent of the domestic mills reporting vs. 50 percent for the weekly estimates. Total raw steel production for the […]
The Far East and Southeast Asian ferrous scrap markets have been on the uptrend since the end of July. Since mid-July, scrap prices have risen approximately $20-$25/metric ton. This coincides with Tokyo Steel in Japan increasing scrap prices twice by approximately $24/MT. The increase in scrap prices were reactionary as steel stockists ramped purchases from […]
For the week ending August 24, 2013, the American Iron & Steel Institute (AISI) reported that the U.S. steel industry produced 1,861,000 net tons of raw steel, a 0.9 percent decrease over the previous week and a 1.9 decrease over the same week one year ago. The estimated capacity utilization rate is 77.7 percent, down […]
July imports rose slightly compared to June but were below the three month and twelve month moving averages. The SMU forecast for August imports is down slightly from July based on license data from this past week. We anticipate August imports to be 2.3-2.4 million tons. Below is the press release from the American Institute […]
Steel Market Update sources are forecasting slightly lower shredded scrap prices in the Midwest and Ohio Valley as we prepare to move into September. Prime grades (such as #1 busheling) are forecast to be sideways to down slightly and cut grades are forecast to move sideways across most areas of the country. This is what […]
We are picking up a very mixed bag over the past two days regarding spot flat rolled pricing. As we go through the process we ask ourselves is the spot pricing market glass half full (meaning prices will go higher from here) or half empty (meaning prices will move lower). We don’t have a clear […]
In three months through May exports of flat products declined as those of long products remained unchanged (see graphic below). Compared to May last year total exports were up by 311 tons. This result breaks down to flat products down 21,166 tons, longs down 29,114 tons and tubulars up 43,176 tons. In all three cases […]
The American Iron & Steel Institute (AISI) reported estimated raw steel production at 1,822,000 net tons for the week ending June 29, 2013. Despite outages and maintenance issues, production rose through July to 1,904,000 net tons of raw steel in the week ending July 20, followed by a drop to 1,871,000 net tons in the […]
Imports of semi finished, and hot worked steel imports through July 2013 Imports of the combined tonnage of billets, blooms and slabs have been trending down for 12 months as have also the combined imports plate and sheet. Total long products have been trending up for all of 2013. These conclusions are based on a […]
Caterpillar Inc. reported weakened sales for February in its rolling three month period that compares current sales with those of the same period one year ago. Machine retail sales were down 13 percent in February further slipping from 4 percent in January. February sales last year were up by 21 percent over the same period […]
U.S. Midwest #1 Busheling Ferrous Scrap (AMM) Prices Drop as an April Pullback Looks Likely After prices for March settled up $40+ the market for April already is starting to shape up significantly weaker. Dealers succeeded in pushing up prices last month but currently it looks like April will be down at least $20 t […]